show multiauth idle-timeout
32-48 Authentication and Authorization Configuration
Parameters
Defaults
If no options are specified, multiple authentication session entries will be displayed for all
sessions, authentication types, MAC addresses, and ports.
Mode
Switch command, read-only.
Example
This example shows how to display multiple authentication session information for port ge.1.1.
C3(su)->show multiauth session port ge.1.1
__________________________________________
Port | ge.1.1 Station address | 00-01-03-86-0A-87
Auth status | success Last attempt | FRI MAY 18 11:16:36 2007
Agent type | dot1x Session applied | true
Server type | radius VLAN-Tunnel-Attr | none
Policy index | 0 Policy name | Administrator
Session timeout | 0 Session duration | 0,00:00:25
Idle timeout | 5 Idle time | 0,00:00:00
Termination time | Not Terminated
show multiauth idle-timeout
Use this command to display the timeout value, in seconds, for an idle session for all
authentication methods.
Syntax
show multiauth idle-timeout
Parameters
None.
Defaults
None.
Mode
Switch command, read-only.
all (Optional) Displays information about all sessions, including those with
terminated status.
agent dot1x | mac |
pwa
(Optional) Displays 802.1X, or MAC, or port web authentication session
information.
mac address (Optional) Displays multiple authentication session entries for specific
MAC address(es).
port port-string (Optional) Displays multiple authentication session entries for the
specified port or ports.
To Next Page
Loading...
Need help?
General