clear radius ipsec
Enterasys C3 Configuration Guide 32-11
Parameters
Mode
Switch command, read-write.
Defaults
At least one of the optional parameters must be entered with this command.
Examples
This example shows how to clear all settings on all RADIUS servers:
C3(su)->clear radius server all
This example shows how to reset the RADIUS timeout to the default value of 20 seconds:
C3(su)->clear radius timeout
clear radius ipsec
Use this command to disable IPsec for one or all RADIUS servers.
Syntax
clear radius ipsec [index]
Parameters
Defaults
If no RADIUS server is specified, IPsec is disabled on all RADIUS servers.
Mode
Switch command, read-write, if security profile = normal.
Switch command, super-user, if security profile = c2
Example
This example disables IPsec on the RADIUS server specified by index 2.
C3(su)->clear radius ipsec 2
retries (Optional) Resets the maximum number of attempts a user can contact the
RADIUS server before timing out to 3.
timeout (Optional) Resets the maximum amount of time to establish contact with
the RADIUS server before timing out to 20 seconds.
server (Optional) Deletes server settings.
index | all For use with the server parameter to clear the server configuration for all
servers or a specific RADIUS server as defined by an index.
realm Resets the realm setting for all servers or a specific RADIUS server as
defined by an index.
index (Optional) Disables IPsec for the configured RADIUS server specified
by index.
To Next Page
Loading...
Need help?
General