show ipv6 ospf virtual-link
Enterasys C3 Configuration Guide 31-47
show ipv6 ospf virtual-link
This command displays the OSPFv3 virtual interface information for a specific area and neighbor.
Syntax
show ipv6 ospf virtual-link areaid neighborid
Parameters
Defaults
None.
Mode
Router privileged execution: C3(su)->router#
Example
This information displays virtual link information for area ID 10 and the neighbor with router ID
of 3.3.3.3.
C3(su)->router(Config)#show ipv6 ospf virtual-link 10 3.3.3.3
Area ID 10
Neighbor IP Address 3.3.3.3
Hello Interval 10
Dead Interval 40
Iftransit Delay Interval 1
Retransmit Interval 5
State DOWN
Metric 0
Neighbor State DOWN
Table 31-13 provides an explanation of the command output.
areaid Specifies the area ID in IP address format (dotted-quad) or as a decimal
value.
neighborid Specifies the neighbor by its router ID, specified in 32-bit dotted quad
format.
Table 31-13 show ipv6 ospf virtual-link Output Details
Output Field What It Displays...
Area ID The area id of the requested OSPFv3 area.
Neighbor Router ID The input neighbor Router ID.
Hello Interval The configured hello interval for the OSPFv3 virtual interface.
Dead Interval The configured dead interval for the OSPFv3 virtual interface.
Iftransit Delay Interval The configured transit delay for the OSPFv3 virtual interface.
Retransmit Interval The configured retransmit interval for the OSPFv3 virtual
interface.
State The OSPFv3 Interface States are: down, loopback, waiting, point-
to-point, designated router, and backup designated router. This is
the state of the OSPFv3 interface.
To Next Page
Loading...
Need help?
General