Enterasys C3G124-24 - Show Sflow Receivers

show sflow receivers
Enterasys C3 Configuration Guide 37-5
show sflow receivers
Use this command to display the contents of the sFlow Receivers Table, or to display information
about a specific sFlow Collector listed in the table.
Syntax
show sflow receivers [index]
Parameters
Defaults
The contents of the sFlow Receivers Table is displayed.
Mode
Switch command, read-only.
Usage
Executing this command without specifying an index into the sFlow Receivers Table displays
information about all the Collectors configured on the switch.
If you specify an individual Collector by its index number, additional information is displayed for
that Collector.
Examples
This example displays the sFlow Receivers Table.
C3(su)->show sflow receivers
Receiver Owner Time out Max Datagram Port IP Address
Index String Size
-------- -------- ---------- ------------ ----- -------------------
1 ets1 17766 1400 6343 10.1.2.117
This example displays information about the Collector with index 1.
C3(su)->show sflow receivers 1
Receiver Index 1
Owner String ets1
Time out 17758
clear sflow port sampler 37-14
set sflow interface 37-14
show sflow interface 37-15
clear sflow interface 37-16
show sflow agent 37-17
For information about... Refer to page...
index (Optional) Specifies a specific Collector to display information about.