Enterasys C3G124-24 - Show Arpinspection Statistics; Clear Arpinspection Validate

show arpinspection statistics
Enterasys C3 Configuration Guide 23-25
IP Address Validation Disabled
Vlan Configuration Log Invalid ACL Name Static flag
---- ------------- ----------- -------------------------------- -----------
5 Disabled Enabled staticARP Enabled
show arpinspection statistics
Use this command to display ARP statistics for all DAI-enabled VLANs or for specific VLANs.
Syntax
show arpinspection statistics [vlan vlan-range]
Parameters
Defaults
If no VLANs are specified, limited statistics for all DAI-enabled VLANs is displayed.
Mode
Switch command, read-write.
Usage
When no specific VLANs are entered, this command displays the number of Forwarded and
Dropped ARP packets per DAI-enabled VLAN. When one or more VLANs are specified, this
command displays more detailed statistics.
Examples
This example shows what is displayed when no VLANs are specified.
C3(su)->show arpinspection statistics
VLAN Forwarded Dropped
---- ------------ ---------
5 0 0
This example shows what information is displayed when one or more VLANs are specified.
C3(su)->show arpinspection statistics vlan 5
VLAN DHCP ACL DHCP ACL Bad Src Bad Dest Invalid
Drops Drops Permits Permits MAC MAC IP
---- ---------- ---------- ---------- ---------- ---------- ---------- ---------
5 0 0 0 0 0 0 0
clear arpinspection validate
Use this command to remove additional optional ARP validation parameters that were previously
configured.
Syntax
clear arpinspection validate {[src-mac] [dst-mac] [ip]}
vlan vlan-range (Optional) Specifies the VLANs for which to display statistics.