Enterasys C3G124-24 User Manual

set linkflap globalstate
Enterasys C3 Configuration Guide 11-27
set linkflap globalstate
Use this command to globally enable or disable the link flap detection function.
Syntax
set linkflap globalstate {disable | enable}
Parameters
Defaults
By default, the function is disabled globally and on all ports.
Mode
Switch mode, read-write.
Usage
By default, the function is disabled globally and on all ports. If disabled globally after per-port
settings have been configured using the linkflap commands, per-port settings will be retained.
Example
This example shows how to globally enable the link trap detection function.
C3(rw)->set linkflap globalstate enable
set linkflap portstate
Use this command to enable or disable link flap monitoring on one or more ports.
Syntax
set linkflap portstate {disable | enable} [port-string]
Table 11-5 show linkflap metrics Output Details
Output Field What it displays...
Port Port designation.
LinkStatus Link status according to the link flap function.
CurrentCount Link down count accruing toward the link flap threshold.
TotalCount Number of link downs since system start,
TimeElapsed Time (in seconds) since the last link down event.
Violations Number of link flap violations on listed ports since system start.
disable | enable Globally disables or enables the link flap detection function.

Enterasys C3G124-24 Specifications

General

Brand	Enterasys
Model	C3G124-24
Category	Switch
Language	English