Configuring the SNMP Management Interface
Enterasys C3 Configuration Guide 12-37
3. Verifies that the specified door TrapSink is, in fact, available. In this case it was built using the
set snmp targetaddr command. This command also specifies that this door leads to the
management station 192.168.190.80, and the “procedure” (targetparams) to cross the doorstep
is called v2ExampleParams.
4. Verifies that the v2ExampleParams description of how to step through the door is, in fact,
there. The agent checks targetparams entries and determines this description was made with
the set snmp targetparams command, which tells exactly which SNMP protocol to use and
what community name to provide. In this case, the community name is mgmt.
5. Verifies that the mgmt community name is available. In this case, it has been configured using
the set snmp community command.
6. Sends the trap notification message.
Configuring the SNMP Management Interface
Purpose
To configure the source IP address used by the SNMP agent when generating SNMP traps.
Commands
show snmp interface
Use this command to display the interface used for the source IP address of the SNMP agent when
generating SNMP traps.
Syntax
show snmp interface
Parameters
None.
Defaults
None.
Mode
Switch mode, read-only.
Example
This example displays the output of this command. In this case, the IP address assigned to
loopback interface 1 will be used as the source IP address of the SNMP agent.
For information about... Refer to page...
show snmp interface 12-37
set snmp interface 12-38
clear snmp interface 12-39
To Next Page
Loading...
