traceroute ipv6
28-10 IPv6 Management
traceroute ipv6
Use this command to discover the routes that packets actually take when traveling to their
destination through the network on a hop-by-hop basis.
Syntax
traceroute ipv6 ipv6-addr
Parameters
Defaults
None.
Mode
Switch mode, read-write.
Usage
This command is also available in router mode.
Example
This example shows how to use traceroute to display a round trip path to host
2001:0db8:1234:5555
C3(su)->traceroute ipv6 2001:0db8:1234:5555::1
Traceroute to 2001:0db8:1234:5555, 30 hops max, 40 byte packets
1 2001:0db8:1234:5555 1.000000e+00 ms 1.000000e+00 ms 1.000000e+00 ms
ipv6-addr Specifies a host to which the route of an IPv6 packet will be traced. Enter the
address in the form documented in RFC 4291, with the address specified in
hexadecimal using 16-bit values between colons.
To Next Page
Loading...
Need help?
General