Setting the Authentication Login Method
32-4 Authentication and Authorization Configuration
Setting the Authentication Login Method
Purpose
To configure the authentication login method to be used for management.
Commands
The commands used to configure the authentication login method are listed below.
show authentication login
Use this command to display the current authentication login method for management.
Syntax
show authentication login
Parameters
None.
Defaults
None.
Mode
Switch command, Read-Only.
Example
This example shows how to display the current authentication login method.
C3(rw)->show authentication login
Authentication Login List Method 1 Method 2 Method 3
------------------------- -------- -------- --------
any tacacs radius local
set authentication login
Use this command to set the authentication login method.
Syntax
set authentication login {any | local | radius | tacacs}
For information about... Refer to page...
show authentication login 32-4
set authentication login 32-4
clear authentication login 32-5
To Next Page
Loading...
