set dhcp pool
Enterasys C3 Configuration Guide 22-13
set dhcp pool
Use this command to create and assign a name to a DHCP server pool of addresses. Up to 16
address pools may be configured on a Enterasys C3. Note that entering this command is not
required to create an address pool before configuring other address pool parameters.
Syntax
set dhcp pool poolname
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example creates an address pool named “auto1.”
C3(rw)->set dhcp pool auto1
set dhcp pool next-server 22-21
clear dhcp pool next-server 22-21
set dhcp pool lease 22-22
clear dhcp pool lease 22-22
set dhcp pool default-router 22-23
clear dhcp pool default-router 22-23
set dhcp pool dns-server 22-24
clear dhcp pool dns-server 22-24
set dhcp pool domain-name 22-25
clear dhcp pool domain-name 22-25
set dhcp pool netbios-name-server 22-26
clear dhcp pool netbios-name-server 22-26
set dhcp pool netbios-node-type 22-27
clear dhcp pool netbios-node-type 22-28
set dhcp pool option 22-28
clear dhcp pool option 22-29
show dhcp pool configuration 22-29
For information about... Refer to page...
poolname Specifies the name of the address pool. Pool names may be up to 31
characters in length.
To Next Page
Loading...
Need help?
General