Enterasys C3G124-24 - Ip Address; Show Ip Interface Output Details

ip address
Enterasys C3 Configuration Guide 25-5
This example shows the output for a loopback interface.
C3(su)->router#show ip interface loopback 2
Loopback 2 is Admin UP
Loopback 2 is Oper DOWN
Primary IP Address is 10.10.10.10 Mask 255.255.255.0
ip address
Use this command to set, remove, or disable a primary or secondary IP address for an interface.
The no form of this command removes the specified IP address and disables the interface for IP
processing.
Syntax
ip address ip-address ip-mask [secondary]
no ip address ip-address ip-mask
Parameters
Defaults
If secondary is not specified, the configured address will be the primary address for the interface.
Mode
Router interface configuration: C3(su)->router(Config-if(Vlan 1))#
Table 25-1 show ip interface Output Details
Output Field What It Displays...
Vlan N Whether the interface is administratively and operationally up or down.
Primary IP Address Inteface’s primary IP address and mask. Set using the ip address command as
described in “ip address” on page 25-5.
Frame Type Encapsulation type used by this interface. Set using the arp command as described
in “arp” on page 25-13.
MAC-Address MAC address mapped to this interface.
Incoming Access
List
Whether or not an access control list (ACL) has been configured for ingress on this
interface using the commands described in Chapter 34, Configuring Access
Control Lists.
MTU Interface’s Maximum Transmission Unit size.
ARP Timeout Duration for entries to stay in the ARP table before expiring. Set using the arp
timeout command as described in “arp timeout” on page 25-15.
Direct Broadcast Whether or not IP directed broadcast is enabled. Set using the ip directed-broadcast
command described in “ip directed-broadcast” on page 25-16.
Proxy Arp Whether or not proxy ARP is enabled or disabled for this interface. Set using the ip
proxy arp command as described in “ip proxy-arp” on page 25-14.
ip-address Specifies the IP address of the interface to be added or removed.
ip-mask Specifies the mask for the associated IP subnet.
secondary (Optional) Specifies that the configured IP address is a secondary address.