Managing Switch Network Addresses and Routes
Enterasys C3 Configuration Guide 18-7
Managing Switch Network Addresses and Routes
Purpose
To display or delete switch ARP table entries, and to display MAC address information.
Commands
show arp
Use this command to display the switch’s ARP table.
Syntax
show arp
Parameters
None.
Defaults
None.
Mode
Switch command, read-only.
For information about... Refer to page...
show arp 18-7
set arp 18-8
clear arp 18-9
traceroute 18-9
show mac 18-10
show mac agetime 18-11
set mac agetime 18-12
clear mac agetime 18-12
set mac algorithm 18-13
show mac algorithm 18-13
clear mac algorithm 18-14
set mac multicast 18-14
clear mac address 18-15
show mac unreserved-flood 18-16
set mac unreserved-flood 18-16
To Next Page
Loading...
Need help?
General