Enterasys C3G124-24 - Clear Sntp Poll-Interval; Set Sntp Poll-Retry

clear sntp poll-interval Configuring SNTP
Enterasys C3 Configuration Guide 20-7
clear sntp poll-interval
Use this command to clear the poll interval between unicast SNTP requests back to the default
value of 512 seconds.
Syntax
clear sntp poll-interval
Parameters
None.
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to clear the SNTP poll interval:
C3(su)->clear sntp poll-interval
set sntp poll-retry
Use this command to set the number of poll retries to a unicast SNTP server.
Syntax
set sntp poll-retry retry
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to set the number of SNTP poll retries to 5:
C3(su)->set sntp poll-retry 5
retry Specifies the number of retries. Valid values are 0 to 10.