Reviewing and Selecting a Boot Firmware Image
Enterasys C3 Configuration Guide 3-31
Reviewing and Selecting a Boot Firmware Image
Purpose
To display and set the image file the switch loads at startup. The C3 switch allows you to
download and store a backup image, which can be selected as the startup image by using the
commands described in this section.
Commands
show boot system
Use this command to display the firmware image the switch loads at startup.
Syntax
show boot system
Parameters
None.
Defaults
None.
Mode
Switch command, read-only.
Example
This example shows how to display the switch’s boot firmware image:
C3(su)->show boot system
Current system image to boot: bootfile
set boot system
Use this command to set the firmware image the switch loads at startup.
Syntax
set boot system filename
Parameters
For information about... Refer to page...
show boot system 3-31
set boot system 3-31
filename Specifies the name of the firmware image file.
To Next Page
Loading...
Need help?
General