Enterasys C3 Configuration Guide xxxv
About This Guide
Welcome to the Enterasys
®
C3 CLI Reference. This manual explains how to access the device’s
Command Line Interface (CLI) and how to use it to configure Enterasys C3 switch devices.
Using This Guide
A general working knowledge of basic network operations and an understanding of CLI
management applications is helpful before configuring the device.
This manual describes how to do the following:
• Access the swtitch CLI.
• Use CLI commands to perform network management and device configuration operations
• Establish and manage Virtual Local Area Networks (VLANs).
• Establish and manage static and dynamically-assigned policy classifications.
• Establish and manage priority classification.
• Configure IP routing and routing protocols, including RIP versions 1 and 2, OSPF, DVMRP,
IRDP, and VRRP.
• Configure IPv6 routing, including OSPFv3.
• Configure security protocols, including 802.1X and RADIUS, SSHv2, PWA, MAC locking, and
MAC authentication.
• Configure access control lists (ACLs).
Structure of This Guide
The guide is organized as follows:
Chapter 1, Introduction, provides an overview of the tasks that can be accomplished using the
CLI interface, an overview of local management requirements, an overview of the device’s factory
default settings, and information about using the Command Line Interface (CLI).
Chapter 2, Configuring Switches in a Stack, provides information about how to configure and
manage stacked switches.
Chapter 3, Basic Configuration, provides how to set basic system properties, how to download a
firmware image, how to configure WebView and Telnet, how to manage configuration files, how
to set the login password, and how to exit the CLI.
Chapter 4, Activating Licensed Features, describes the commands used to enable advanced
routing and IPv6 routing licensed features.
Important Notice
Depending on the firmware version used in your C3 device, some features described in this
document may not be supported. Refer to the Release Notes for your device to determine which
features are supported.
To Next Page
Loading...
Need help?
General