clear rmon capture
Enterasys C3 Configuration Guide 21-23
Mode
Switch command, read-write.
Example
This example shows how to create RMON capture entry 1 to “listen” on channel 628:
C3(rw)->set rmon capture 1 628
clear rmon capture
Use this command to clears an RMON capture entry.
Syntax
clear rmon capture index
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to clear RMON capture entry 1:
C3(rw)->clear rmon capture 1
index Specifies the capture entry to be cleared.
To Next Page
Loading...
Need help?
General