show spantree bpdu-forwarding
13-10 Spanning Tree Configuration
Example
This example shows how to reset the Spanning Tree version:
C3(su)->clear spantree version
show spantree bpdu-forwarding
Use this command to display the Spanning Tree BPDU forwarding mode.
Syntax
show spantree bpdu-forwarding
Parameters
None.
Defaults
None.
Mode
Switch command, read-only.
Example
This example shows how to display the Spanning Tree BPDU forwarding mode:
C3(su)->show spantree bpdu-forwarding
BPDU forwarding is disabled.
set spantree bpdu-forwarding
Use this command to enable or disable Spanning Tree BPDU forwarding. By default BPDU
forwarding is disabled.
Syntax
set spantree bpdu-forwarding {disable | enable}
Parameters
Defaults
By default BPDU forwarding is disabled.
Mode
Switch command, read-write.
Usage
In order to enable Spanning Tree pass through on the switch, the Spanning Tree protocol must be
disabled (set spantree disable) and BPDU forwarding must be enabled with this command. When
disable | enable Disables or enables BPDU forwarding;.
To Next Page
Loading...
Need help?
General