Enterasys C3G124-24 - Tunnel Destination; Tunnel Mode

tunnel destination
25-10 IP Configuration
tunnel destination
This command specifies the IPv4 destination transport address of the tunnel.
Syntax
tunnel destination ipv4-addr
no tunnel destination
Parameters
Defaults
None.
Mode
Router interface configuration: C3(su)->router(Config-if(Tnnl 1))#
Usage
The no form of this command removes the destination IPv4 address for the tunnel interface being
configured.
Example
The following example configures the destination IPv4 address for tunnel 1.
C3(su)->router(Config)# interface tunnel 1
C3(su)->router(Config-if(Tnnl 1))#
C3
(su)->router(Config-if(Tnnl 1))# tunnel destination 192.168.10.20
tunnel mode
This command specifies the mode of the tunnel interface.
Syntax
tunnel mode ipv6ip
no tunnel mode ipv6ip
Parameters
Defaults
None.
Mode
Router interface configuration: C3(su)->router(Config-if(Tnnl 1))#
Usage
The no form of this command removes the mode of the tunnel.
ipv4-addr The IPv4 destination address of the tunnel.
ipv6ip Specifies that the tunnel mode is IPv6 over IPv4