show txqmonitor Transmit Queue Monitoring Configuration
Enterasys C3 Configuration Guide 9-5
Defaults
If port-string is not specified with the ignorepause or down parameters, all ports will be cleared.
Mode
Switch command, read-write.
Example
This example re-enables port ge.1.1 that was disabled by transmit queue monitoring.
C3(su)-> clear txqmonitor down ge.1.1
show txqmonitor
Use this command to display information about transmit queue monitoring.
Syntax
show txqmonitor [ downports | downtime | globalstate | ignorepause | minrate |
operstatus | threshold ]
Parameters
Defaults
If no parameter is specified, all transmit queue monitoring information is displayed.
Mode
Switch mode, read-only.
Examples
This example displays the global state of transmit queue monitoring.
C3(su)-> show txqmonitor globalstate
txqmonitor enabled
This example displays the currently configured trigger values.
C3(su)->show txqmonitor threshold
downports (Optional) Lists the ports disabled by transmit queue monitoring.
downtime (Optional) Displays the currently configured downtime interval in
seconds.
globalstate (Optional) Displays the global state of transmit queue monitoring,
either enabled or disabled.
ignorepause (Optional) Displays the ports currently discarding received pause
frames.
minrate (Optional) Displays the currently configured minimum acceptable
transmit rate per sampling period.
operstatus (Optional) Displays the operational status of all ports relative to
transmit queue monitoring. Ports are either operational or disabled.
threshold (Optional) Display the currently configured trigger values for transmit
queue monitoring corrective actions.
To Next Page
Loading...
