Enterasys C3G124-24 - Show Lldp Port Remote-Info

show lldp port remote-info
Enterasys C3 Configuration Guide 10-21
show lldp port remote-info
Use this command to display the remote system information stored for a remote device connected
to a local port. You can use this information to detect misconfigurations or incompatibilities
between the local port and the attached endpoint device (remote port).
Syntax
show lldp port remote-info [port-string]
Parameters
Defaults
If port-string is not specified, remote system information will be displayed for all ports.
Mode
Switch command, read-only.
Example
This example shows how to display the remote system information stored for port ge.3.1. The
remote system information was received from an IP phone, which is an LLDP-MED-enabled
device. Table 10-5 describes the output fields that are unique to the remote system information
displayed for a MED-enabled device.
C3(ro)->show lldp port remote-info ge.3.1
Local Port : ge.3.1 Remote Port Id : 00-09-6e-0e-14-3d
---------------------
Mgmt Addr : 0.0.0.0
Chassis ID : 0.0.0.0
Device Type : Communication Device Endpoint (class III)
Sys Name : AVE0E143D
Sys Cap Supported/Enabled : bridge,telephone/bridge
Auto-Neg Supported/Enabled : yes/yes
Auto-Neg Advertised : 10BASE-T, 10BASE-TFD
: 100BASE-TX, 100BASE-TXFD
: pause, Spause
Operational Speed/Duplex/Type : 100/full/TX
Network Policy
(app/tag/vlanId/cos/dscp) : voice/untagged/0/6/46
Hardware Revision : 4610D01A
Firmware Revision : b10d01b2_7.bin
Software Revision : a10d01b2_7.bin
Serial Number : 05GM42004348
Manufacturer : Avaya
Model Number : 4610
Note that the information fields displayed by the show lldp port remote-info command will vary,
depending on the type of remote device that is connected to the port.
port-string (Optional) Displays remote system information for one or a range of
ports.