Enterasys C3G124-24 - Clear Dhcp Pool Next-Server; Set Dhcp Pool Next-Server

set dhcp pool next-server
Enterasys C3 Configuration Guide 22-21
Example
This example removes the boot image filename from address pool named “auto1.”
C3(rw)->clear dhcp pool auto1 bootfile
set dhcp pool next-server
Use this command to specify the file server from which the default boot image is to be loaded by
the client.
Syntax
set dhcp pool poolname next-server ip-address
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example specifies the file server from which clients being served by address pool “auto1”
should download the boot image file “image1.img.”
C3(rw)->set dhcp pool auto1 bootfile image1.img
C3(rw)->set dhcp pool auto1 next-server 10.1.1.10
clear dhcp pool next-server
Use this command to remove the boot image file server from the address pool being configured.
Syntax
clear dhcp pool poolname next-server
Parameters
Defaults
None.
Mode
Switch command, read-write.
poolname Specifies the name of the address pool. Pool names may be up to 31
characters in length.
ip-address Specifies the IP address of the file server the DHCP client should contact
to load the default boot image.
poolname Specifies the name of the address pool. Pool names may be up to 31
characters in length.