Enterasys C3 Configuration Guide 8-1
8
Configuring System Power and PoE
The commands in this chapter allow you to review and set system power and PoE (Power over
Ethernet) parameters, including the power available to the system, the usage threshold for each
module, whether or not SNMP trap messages will be sent when power status changes, and per-
port PoE settings.
For more extensive configuration information, refer to the “Configuring Power over Ethernet
Management” feature guide on the Enterasys Networks web site: https://extranet.enterasys.com/
downloads/
Commands
show inlinepower
Use this command to display system power properties.
Syntax
show inlinepower
Parameters
None.
Defaults
None.
Important Notice
The commands in this section apply only to PoE-equipped devices. Consult the Installation Guide for your
product to determine if it is PoE-equipped.
For information about... Refer to page...
show inlinepower 8-1
set inlinepower threshold 8-2
set inlinepower trap 8-3
set inlinepower detectionmode 8-3
show port inlinepower 8-4
set port inlinepower 8-5
To Next Page
Loading...
