clear macauthentication password
Enterasys C3 Configuration Guide 32-33
Example
This example shows how to set the MAC authentication password to “macauth”:
C3(su)->set macauthentication password macauth
clear macauthentication password
Use this command to clear the MAC authentication password.
Syntax
clear macauthentication password
Parameters
None.
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to clear the MAC authentication password:
C3(su)->clear macauthentication password
set macauthentication port
Use this command to enable or disable one or more ports for MAC authentication.
Syntax
set macauthentication port {enable | disable} port-string
Parameters
Defaults
None.
Mode
Switch command, read-write.
enable | disable Enables or disables MAC authentication.
port-string Specifies port(s) on which to enable or disable MAC authentication. For a
detailed description of possible port-string values, refer to “Port String
Syntax Used in the CLI” on page 11-1.
To Next Page
Loading...
