Enterasys C3G124-24 User Manual

Configuring SNTP clear sntp interface
20-12
vlan 100 192.168.10.1
clear sntp interface
Use this command to clear the interface used for the source IP address of the SNTP client back to
the default of the Host interface.
Syntax
clear sntp interface
Parameters
None.
Defaults
None.
Mode
Switch command, read-write.
Example
This command returns the interface used for the source IP address of the SNTP client back to the
default of the Host interface.
C3(rw)->show sntp interface
vlan 100 192.168.10.1
C3(rw)->clear sntp interface
C3(rw)->
SNTP Authentication Commands
set sntp authenticate
Use this command to enable or disable the authentication mechanism for received SNTP traffic
from servers.
Syntax
set sntp authenticate {enable | disable}
For information about... Refer to page...
set sntp authenticate 20-12
set sntp authentication-key 20-13
clear sntp authentication-key 20-14
set sntp trusted-key 20-14
clear sntp trusted-key 20-15

Enterasys C3G124-24 Specifications

General

Brand	Enterasys
Model	C3G124-24
Category	Switch
Language	English