Enterasys C3G124-24 - Configuring ICMP Redirects; Commands; Ip Icmp Redirect Enable; Purpose

Configuring ICMP Redirects
Enterasys C3 Configuration Guide 25-23
6 192.141.100.6 0.000 ms 0.000 ms 10.000 ms
7 192.141.90.183 0.000 ms 0.000 ms 0.000 ms
Configuring ICMP Redirects
Purpose
Disable or enable sending ICMP redirect packets to the switch CPU for processing, at a global
level and at an interface level. By default, sending ICMP redirects is enabled globally and on all
interfaces. Disabling sending ICMP redirects can reduce CPU usage in certain deployments.
Commands
ip icmp redirect enable
Use this command to enable or disable sending ICMP redirects to the CPU for processing on a
global level or on a specific interface. The no form of this command disables sending ICMP
redirects to the CPU.
Syntax
ip icmp redirect enable
no ip icmp redirect enable
Parameters
None.
Defaults
By default, sending ICMP redirects to the CPU is enabled globally and on all interfaces.
Mode
Router global configuration mode: C3(su)->router(Config)#
Interface configuration mode: C3(su)->Router1(Config-if(Vlan 1))#
Usage
You can use this command in router global configuration mode to enable or disable sending ICMP
redirects globally on the switch.
You can use this command in router interface configuration mode to enable or disable sending
ICMP redirects only on specific interfaces.
For information about... Refer to page...
ip icmp redirect enable 25-23
show ip icmp redirect 25-24