Enterasys C3G124-24 - Show Ipv6 Ospf Interface Stats

show ipv6 ospf interface stats
Enterasys C3 Configuration Guide 31-41
show ipv6 ospf interface stats
This command displays statistics for a specific interface. Statistics are displayed only if OSPFv3 is
enabled.
Syntax
show ipv6 ospf interface stats vlan vlanid
Parameters
Defaults
None.
Mode
Router privileged execution: C3(su)->router#
Example
This example shows how to display statistics for VLAN 80.
C3(su)->router>show ipv6 ospf interface stats vlan 80
OSPFv3 Area ID 0.0.0.20
Spf Runs 7
Area Border Router Count 0
AS Border Router Count 0
Area LSA Count 5
IPv6 Address FE80::211:88FF:FE56:5D8F/128
OSPF Interface Events 2
Virtual Events 0
Neighbor Events 0
External LSA Count 1
LSAs Received 1903
Originate New LSAs 4198
Sent Packets 1053
Metric Cost The priority of the path. Low costs have a higher priority than high
costs.
OSPF MTU-ignore Whether to ignore MTU mismatches in database descriptor
packets sent from neighboring routers. The following information
only displays if OSPF is initialized on the interface:
OSPF Interface Type Broadcast LANs, such as Ethernet and IEEE 802.5, take the value
broadcast. Tunnel interfaces take the value point-to-point.
State The OSPF Interface States are: down, loopback, waiting, point-to-
point, designated router, and backup designated router.
Designated Router The router ID representing the designated router.
Backup Designated Router The router ID representing the backup designated router.
Number of Link Events The number of link events.
Table 31-7 show ipv6 ospf interface Command Output Details (Continued)
Output Field What It Displays...
vlan vlanid Specifies the VLAN interface for which to display statistics.