clear rmon filter
21-20 RMON Configuration
Defaults
If owner is not specified, it will be set to monitor.
If no other options are specified, none (0) will be applied.
Mode
Switch command, read-write.
Example
This example shows how to create RMON filter 1 and apply it to channel 9:
C3(rw)->set rmon filter 1 9 offset 30 data 0a154305 dmask ffffffff
clear rmon filter
Use this command to clear an RMON filter entry.
Syntax
clear rmon filter {index index | channel channel}
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to clear RMON filter entry 1:
C3(rw)->clear rmon filter index 1
index index |
channel channel
Clears a specific filter entry, or all entries belonging to a specific channel.
To Next Page
Loading...
