Enterasys C3G124-24 - Show Ipv6 Traffic; Show Ipv6 Summary Output Details

show ipv6 traffic
29-28 IPv6 Configuration
Defaults
None.
Mode
Router privileged execution: C3(su)->router#
Router user execution: C3(su)->router>
Usage
Use the command without parameters to display the count summary for only the best routes. Use
all to display the count summary for all routes, including best and non-best routes.
Example
This example illustrates the summary information displayed by this command.
C3(su)->router>show ipv6 route summary all
IPv6 Routing Table Summary - 6 entries
Connected Routes 3
Static Routes 3
OSPF Routes 0
Intra Area Routes 0
Inter Area Routes 0
External Type-1 Routes 0
External Type-2 Routes 0
Total routes 6
Number of Prefixes:
/0: 1, /64: 5
Table 29-4 provides an explanation of the command output.
show ipv6 traffic
Use this command to show traffic and statistics for IPv6 and ICMPv6.
Syntax
show ipv6 traffic [interface]
Table 29-4 show ipv6 summary Output Details
Output Field What It Displays...
Connected Routes Total number of connected routes in the routing table.
Static Routes Total number of static routes in the routing table.
OSPF Routes Total number of routes installed by OSPFv3 protocol.
Number of Prefixes Summarizes the number of routes with prefixes of different lengths
Total Routes Total number of routes in the routing table.