show port inlinepower
8-4 Configuring System Power and PoE
Parameters
Defaults
Default detection mode is auto.
Mode
Switch command, read-write.
Usage
This command is used to specify how the switch should detect PDs connected to its ports. The PoE
hardware in the switches can use the IEEE 802.3 PoE standard (resistor-based) method or a
proprietary method using capacitor detection.
If auto is configured, the switch will first use the IEEE resistor-based detection method, and if that
fails, the switch will use the capacitor-based detection method. If ieee is configured, only the IEEE
resistor-based detection method will be used.
Example
This example sets the switch’s PD detection mode to the IEEE 802.3 PoE standard only.
C3
(su)->set inlinepower detectionmode ieee
show port inlinepower
Use this command to display information about ports on the switch supporting PoE.
Syntax
show port inlinepower [port-string]
Parameters
Defaults
If no port string is specified, information for all PoE ports will be displayed.
Mode
Switch command, read-only.
Example
This example shows how to display PoE information for port ge.2.1. In this case, the port’s
administrative state, PoE priority and class have not been changed from default values:
auto Specifies that the switch will use the standard IEEE 802.3 PoE detection
method first. If that fails, then the switch will use the legacy (pre-IEEE
802.3 PoE standard) capacitance method of detection.
ieee Specifies that the switch will only use the standard IEEE 802.3 PoE
detection method. (Refer to the Release Notes for your product for the
specific IEEE 802.3 PoE standards supported by your product.)
port-string (Optional) Displays information for specific PoE port(s).
To Next Page
Loading...
Need help?
General