Enterasys C3G124-24 - Clear Sntp Poll-Retry; Set Sntp Poll-Timeout; Clear Sntp Poll-Timeout

Configuring SNTP clear sntp poll-retry
20-8
clear sntp poll-retry
Use this command to clear the number of poll retries to a unicast SNTP server.
Syntax
clear sntp poll-retry
Parameters
None.
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to clear the number of SNTP poll retries:
C3(su)->clear sntp poll-retry
set sntp poll-timeout
Use this command to set the poll timeout (in seconds) for a response to a unicast SNTP request.
Syntax
set sntp poll-timeout timeout
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to set the SNTP poll timeout to 10 seconds:
C3(su)->set sntp poll-timeout 10
clear sntp poll-timeout
Use this command to clear the SNTP poll timeout.
Syntax
clear sntp poll-timeout
timeout Specifies the poll timeout in seconds. Valid values are 1 to 30.