Enterasys C3G124-24 - Show Ip Pimsm Componenttable; Show Ip Pimsm Output Details

show ip pimsm componenttable
Enterasys C3 Configuration Guide 27-41
PIM-SM INTERFACE STATUS
VlanId Interface Mode Protocol State
--------- -------------- ----------------
8 Disable Non-Operational
16 Enable Operational
17 Enable Operational
20 Enable Operational
30 Enable Operational
31 Disable Non-Operational
32 Disable Non-Operational
33 Disable Non-Operational
Table 27-7 provides an explanation of the command output.
show ip pimsm componenttable
This command displays the table containing objects specific to a PIM domain. One row exists for
each domain to which the router is connected.
Syntax
show ip pimsm componenttable
Parameters
None.
Defaults
None.
Mode
Any router mode.
Example
This example shows how to display PIM router information:
C3(su)->router> show ip pimsm componenttable
Table 27-7 show ip pimsm Output Details
Output Field What it displays
Admin Mode This field indicates whether PIM-SM is enabled or disabled. This is a configured
value.
Join/Prune Interval
(secs)
This field shows the interval at which periodic PIM-SM Join/Prune messages are to
be sent.
VlanId VLAN id associated with the PIM IP Interface.
Interface Mode This field indicates whether PIM-SM is enabled or disabled on the interface. This is a
configured value.
Protocol State This field indicates the current state of the PIM-SM protocol on the interface.
Possible values are Operational or Non-Operational.