Enterasys C3G124-24 User Manual

clear dhcp pool option
Enterasys C3 Configuration Guide 22-29
Examples
This example configures DHCP option 19, which specifies whether the client should configure its
IP layer for packet forwarding. In this case, IP forwarding is enabled with the 01 value.
C3(rw)->set dhcp pool auto1 option 19 hex 01
This example configures DHCP option 72, which assigns one or more Web servers for DHCP
clients. In this case, two Web server addresses are configured.
C3(rw)->set dhcp pool auto1 option 72 ip 168.24.3.252 168.24.3.253
clear dhcp pool option
Use this command to remove a DHCP option from the address pool being configured.
Syntax
clear dhcp pool poolname option code
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example removes option 19 from address pool “auto1.”
C3(rw)->clear dhcp pool auto1 option 19
show dhcp pool configuration
Use this command to display configuration information for one or all address pools.
Syntax
show dhcp pool configuration {poolname | all}
Parameters
Defaults
None.
poolname Specifies the name of the address pool. Pool names may be up to 31
characters in length.
code Specifies the DHCP option code, as defined in RFC 2132. Value can range
from 1 to 254.
poolname Specifies the name of the address pool. Pool names may be up to 31
characters in length.

Enterasys C3G124-24 Specifications

General

Brand	Enterasys
Model	C3G124-24
Category	Switch
Language	English