set port inlinepower
Enterasys C3 Configuration Guide 8-5
C3(su)->show port inlinepower ge.2.1
Port Type Admin Oper Priority Class Power(W)
---- ---- ----- ---- -------- ----- --------
ge.2.1 wireless auto searching low 0 15.4
set port inlinepower
Use this command to configure PoE parameters on one or more ports.
Syntax
set port inlinepower port-string {[admin {off | auto}] [priority {critical | high
| low}] [type type]}
Parameters
Defaults
At least one of the optional parameters must be entered.
Table 8-2 show port inlinepower Output Details
Output Field What it Displays
Port The port being displayed in this row.
Type A text string describing the type of device connected to the port, set with the set
port inlinepower command.
Admin The port’s PoE administrative state, off (disabled) or auto (on). Can be set with
the set port inlinepower command.
Oper The operational mode of the port. Values displayed can be:
• Searching — no device is connected to the port.
• Delivering Power — power being delivered to connected device.
• Over Budget — connected device requires more power than the switch can
allocate to that port.
• Overload — connected device consumed more power than it was allowed.
• Other Fault — another PoE error has been detected, such as a short on the
PoE load, error with PoE signaling, general error detection.
Priority The port’s priority for PoE allocation. Values can be critical (highest), high or
low. Can be set with the set port inlinepower command.
Class The PoE class of the connected powered device.
Power (W) The amount of power being delivered to the port.
port-string Specifies the port(s) on which to configure PoE.
admin off | auto (Optional) Sets the PoE administrative state to off (disabled) or auto (on).
When you set the admin state to off, PoE power is disabled on that port.
priority critical |
high | low
(Optional) Sets the port(s) priority for the PoE allocation algorithm to
critical (highest), high or low.
type type (Optional) Specifies a string describing the type of device connected to a
port. The string can be a maximum of 20 characters.
To Next Page
Loading...
