arp timeout
Enterasys C3 Configuration Guide 25-15
arp timeout
Use this command to set the duration (in seconds) for dynamically learned entries to remain in the
ARP table before expiring. The no form of this command restores the default value of 14,400
seconds.
arp timeout seconds
no arp timeout
Parameters
Defaults
14,400 seconds.
Mode
Global configuration: C3(su)->router(Config)#
Example
This example shows how to set the ARP timeout to 7200 seconds:
C3(su)->router(Config)#arp timeout 7200
clear arp-cache
Use this command to delete all nonstatic (dynamic) entries from the ARP table.
clear arp-cache
Parameters
None.
Mode
Privileged EXEC: C3(su)->router#
Defaults
None.
Example
This example shows how to delete all dynamic entries from the ARP table:
C3(su)->router#clear arp-cache
seconds Specifies the time in seconds that an entry remains in the ARP cache. Valid
values are 0 - 65535. A value of 0 specifies that ARP entries will never be
aged out.
To Next Page
Loading...
