Enterasys C3G124-24 - Configuring Secure Shell (SSH); Commands; Purpose; Set Ssh

Configuring Secure Shell (SSH)
Enterasys C3 Configuration Guide 32-89
Configuring Secure Shell (SSH)
Purpose
To review, enable, disable, and configure the Secure Shell (SSH) protocol, which provides secure
Telnet. The switch can support up to two concurrent SSH sessions.
Commands
show ssh status
Use this command to display the current status of SSH on the switch.
Syntax
show ssh status
Parameters
None.
Defaults
None.
Mode
Switch command, read-only.
Example
This example shows how to display SSH status on the switch:
C3(su)->show ssh status
SSH Server status: Disabled
set ssh
Use this command to enable, disable or reinitialize SSH server on the switch. By default, the SSH
server is disabled. The switch can support up to two concurrent SSH sessions.
Syntax
set ssh {enabled | disabled | reinitialize}
For information about... Refer to page...
show ssh status 32-89
set ssh 32-89
set ssh hostkey 32-90