clear cos port-resource irl
Enterasys C3 Configuration Guide 15-31
2.0 1 irl kbps 10000 drop none
This example displays the flood control resources configured for group 1.0.
C3(su)->show cos port-resource flood-ctrl 1.0
'?' after the rate value indicates an invalid rate value
Group Resource Type Unit Rate Rate Limit Action
Index type
--------- ----------- ---------- ---- ---------- --------------- ------
1.0 ucast flood-ctrl pps 20 drop none
1.0 mcast flood-ctrl pps 10 drop none
1.0 bcast flood-ctrl pps 5 drop none
clear cos port-resource irl
Use this command to clear inbound rate limit resources to default values.
Syntax
clear cos port-resource irl {all | group-type-index [irl-index [unit] [rate]
[type]]}
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example clears the data rate to 0 for IRL resource index 1 for group 2.0.
C3(su)->clear cos port-resource irl 2.0 1 rate
all Clear all IRL resources for all port groups.
group-type-index Specifies an inbound rate limiting port group/type index. Valid entries are
in the form of group#.port-type.
Valid values for group# can range from 0 to 7. Valid values for port-type
can range from 0 to 1, although only port type 0 is currently supported.
For example, port group 3 would be specified as 3.0.
irl-index (Optional) Inbound rate limiter resource index associated with the
specified port group. Valid values range from 0 to 99.
unit Clear the unit of measure for the inbound rate limiter.
rate Clear the data rate for this inbound rate limiter.
type Clear the action for the rate limiter.
To Next Page
Loading...
Need help?
General