show radius
Enterasys C3 Configuration Guide 32-7
Parameters
Defaults
If no parameters are specified, all RADIUS configuration information will be displayed.
Mode
Switch command, read-only.
Example
This example shows how to display RADIUS configuration information:
C3(rw)->show radius
RADIUS status: Enabled
RADIUS retries: 3
RADIUS timeout: 20 seconds
RADIUS attribute mgmt password: standard
RADIUS Server IP Address Auth-Port Realm-Type IPsec
-------------- ---------- --------- ----------------- --------
10 172.16.20.10 1812 management-access disabled
Table 32-1 provides an explanation of the command output.
status (Optional) Displays the RADIUS server’s enable status.
retries (Optional) Displays the number of retry attempts before the RADIUS server
times out.
timeout (Optional) Displays the maximum amount of time (in seconds) to establish
contact with the RADIUS server before retry attempts begin.
server (Optional) Displays RADIUS server configuration information.
index | all For use with the server parameter to show server configuration for all
servers or a specific RADIUS server as defined by an index.
Table 32-1 show radius Output Details
Output Field What It Displays...
RADIUS status Whether RADIUS is enabled or disabled.
RADIUS retries Number of retry attempts before the RADIUS server times out. The default value of 3
can be reset using the set radius command as described in “set radius” on
page 32-8.
RADIUS timeout Maximum amount of time (in seconds) to establish contact with the RADIUS server
before retry attempts begin. The default value of 20 can be reset using the set
radius command as described in “set radius” on page 32-8.
RADIUS attribute
mgmt password:
Whether RADIUS password authentication management is configured as standard
or MS-CHAPv2. Configured with the command “set radius attribute mgmt password”
on page 32-16.
To Next Page
Loading...
Need help?
General