set logging application Configuring System Logging
Enterasys C3 Configuration Guide 19-9
set logging application
Use this command to set the severity level of log messages for one or all applications and the
servers to which messages will be sent for one or all applications.
Syntax
set logging application {[mnemonic | all]} [level level] [servers servers]
Parameters
mnemonic Specifies a case sensitive mnemonic abbreviation of an application to be
logged. This parameter will vary depending on the number and types of
applications running on your system. To display a complete list, use the
show logging application command as described in “show logging
application” on page 19-7. Sample mnemonics and their corresponding
applications are listed in Table 19-3 on page 19-9.
Note: Mnemonic values are case sensitive and must be typed as they appear in
Table 19-3.
all Sets the logging severity level for all applications.
level level (Optional) Specifies the severity level at which the server will log
messages for applications. Valid values and corresponding levels are:
1 — emergencies (system is unusable)
2 — alerts (immediate action required)
3 — critical conditions
4 — error conditions
5 — warning conditions
6 — notifications (significant conditions)
7 — informational messages
8 — debugging messages
servers servers (Optional) Specifies by index number the Syslog servers to which
messages will be sent. Valid values range from 1 to 8 and are set using
the set logging server (page 19-4) command.
Table 19-3 Mnemonic Values for Logging Applications
Mnemonic Application
CLIWEB Command Line Interface and Webview management
SNMP Simple Network Management Protocol
STP Spanning Tree Protocol
Driver Hardware drivers
System Non-application items such as general chassis management
Stacking Stacking management (if applicable)
UPN User Personalized Networking
Router Router
To Next Page
Loading...
