show ip igmp groups
Enterasys C3 Configuration Guide 17-13
Multicast TTL currently defaults to 1
IGMP Version is 2
Query Interval is 125 (secs)
Query Max Response Time is 100 (1/10 of a second)
Robustness is 2
Startup Query Interval is 31 (secs)
Startup Query Count is 2
Last Member Query Interval is 10 (1/10 of a second)
Last Member Query Count is 2
show ip igmp groups
Use this command to display a list of IGMP streams and client connection ports.
Syntax
show ip igmp groups
Parameters
None.
Defaults
None.
Mode
Any router mode.
Example
This example shows how to display information about IGMP groups:
C3(su)->router#show ip igmp groups
REGISTERED MULTICAST GROUP DETAILS
Multicast Version1
IP Address Last Reporter Up Time Expiry Time Host Timer
--------------- --------------- ------- ------------ ------------ ----------
228.1.1.1 12.12.12.2 27
ip igmp query-interval
Use this command to set the IGMP query interval on a routing interface. The no form of this
command resets the IGMP query interval to the default value of 125 seconds.
Syntax
ip igmp query-interval time
no ip igmp query-interval
Parameters
time Specifies the IGMP query interval. Valid values are from 1 to 3600
seconds. Default is 125 seconds.
To Next Page
Loading...
Need help?
General