Enterasys C3G124-24 - Set Gvrp; Show Gvrp Configuration Output Details

set gvrp
Enterasys C3 Configuration Guide 14-23
Example
This example shows how to display GARP timer information on ports 1 through 10 in unit 1:
C3(su)->show garp timer ge.1.1-10
Port based GARP Configuration: (Timer units are centiseconds)
Port Number Join Leave Leaveall
----------- ---------- ---------- ----------
ge.1.1 20 60 1000
ge.1.2 20 60 1000
ge.1.3 20 60 1000
ge.1.4 20 60 1000
ge.1.5 20 60 1000
ge.1.6 20 60 1000
ge.1.7 20 60 1000
ge.1.8 20 60 1000
ge.1.9 20 60 1000
ge.1.10 20 60 1000
Table 14-3 provides an explanation of the command output. For details on using the set gvrp
command to enable or disable GVRP, refer to “set gvrp” on page 14-23. For details on using the set
garp timer command to change default timer values, refer to “set garp timer” on page 14-24.
set gvrp
Use this command to enable or disable GVRP globally on the device or on one or more ports.
Syntax
set gvrp {enable | disable} [port-string]
Parameters
Defaults
If port-string is not specified, GVRP will be disabled or enabled for all ports.
Note: For a functional description of the terms join, leave, and leaveall timers, refer to the
standard IEEE 802.1Q documentation, which is not supplied with this device.
Table 14-3 show gvrp configuration Output Details
Output Field What It Displays...
Port Number Port designation. For a detailed description of possible port-string values, refer to
“Port String Syntax Used in the CLI” on page 11-1.
Join Join timer setting.
Leave Leave timer setting.
Leaveall Leavall timer setting.
disable |
enable
Disables or enables GVRP on the device.
port-string (Optional) Disables or enables GVRP on specific port(s). For a detailed
description of possible port-string values, refer to “Port String Syntax Used in
the CLI” on page 11-1.