Configuring System Logging clear logging local
19-12
Defaults
You must enter both the console and file parameters with this command. If you do not enter the
sfile parameter, the security audit log status remains unchanged.
Mode
Switch command, read-write, if security profile = normal.
Switch command, super-user, if security profile = c2
Switch command, super-user for security audit log.
Usage
If you do not use this command to change the default settings, logging to the console is enabled
logging to the Syslog persistent file is disabled, and logging to the security audit log is disabled by
default.
Examples
This command shows how to disable logging to the console and enable logging to a persistent file:
C3(su)->set logging local console disable file enable
This example shows how to enable logging to the security audit log.
C3(su)->set logging local console disable file enable sfile enable
clear logging local
Use this command to reset the console, Syslog file, and security audit log logging settings for the
local session back to their default settings. The default settings are local console enabled, Syslog
persistent store file disabled, and security audit log file disabled.
Syntax
clear logging local
Parameters
None.
Defaults
None.
Mode
Switch command, read-write, if security profile = normal.
Switch command, super-user, if security profile = c2
Switch command, super-user for security audit log.
Example
This example shows how to return local logging settings to their default settings.:
C3(su)->clear logging local
To Next Page
Loading...
