Enterasys C3G124-24 - Configuring SNMP Target Parameters; Commands; Purpose; Show Snmp Targetparams

Configuring SNMP Target Parameters
12-22 SNMP Configuration
Parameters
Defaults
None.
Mode
Switch mode, read-write, when security profile = normal.
Switch mode, super-user, when security profile = C2.
Example
This example shows how to delete SNMP MIB view “public”:
C3(su)->clear snmp view public 1.3.6.1
Configuring SNMP Target Parameters
Purpose
To review and configure SNMP target parameters. This controls where and under what
circumstances SNMP notifications will be sent. A target parameter entry can be bound to a target
IP address allowed to receive SNMP notification messages with the set snmp targetaddr
command (“set snmp targetaddr” on page 12-26).
Commands
show snmp targetparams
Use this command to display SNMP parameters used to generate a message to a target.
Syntax
show snmp targetparams [targetParams] [volatile | nonvolatile | read-only]
Parameters
viewname Specifies the MIB view name to be deleted.
subtree Specifies the subtree name of the MIB view to be deleted.
For information about... Refer to page...
show snmp targetparams 12-22
set snmp targetparams 12-24
clear snmp targetparams 12-25
targetParams (Optional) Displays entries for a specific target parameter.
volatile | nonvolatile |
read-only
(Optional) Displays target parameter entries for a specific storage
type.