Assigning Ports to Policy Profiles
Enterasys C3 Configuration Guide 15-15
Assigning Ports to Policy Profiles
Purpose
To assign and unassign ports to policy profiles.
Commands
set policy port
Use this command to assign ports to a policy profile.
Syntax
set policy port port-string profile-index
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to allow Ethernet ports 5 through 15 in unit 1 to transmit frames
according to policy profile 1:
C3(su)->set policy port ge.1.5-15 1
Note: Refer to the latest firmware Release Notes for this platform for information about policy limits
for this platform.
For information about... Refer to page...
set policy port 15-15
clear policy port 15-16
show policy port 15-16
port-string Specifies the port(s) to add to the policy profile. For a detailed description
of possible port-string values, refer to “Port String Syntax Used in the CLI”
on page 11-1.
profile-index Specifies the ID of the policy profile (role) to which the port(s) will be
added. This value must match the profile-index value assigned using the
set policy profile command (“set policy profile” on page 15-3) in order
for a policy profile to be active on the specified port.
To Next Page
Loading...
