show port mdix
Enterasys C3 Configuration Guide 11-19
show port mdix
Use this command to display the status of cable connection type configuration mode for one or
more ports. Switch ports can automatically detect and configure the required cable type, either
straight through (MDI) or cross-over (MDIX), or the ports can be configured to only allow one
type of cable type, either MDI or MDIX.
Syntax
show port mdix {all|auto|forced-auto|mdi|mdix} [port-string]
Parameters
Defaults
If port-string is not specified, information is displayed for all ports.
Mode
Switch command, read-only.
Example
This example displays information about ports configured for MDIX only mode.
C3(su)->show port mdix mdix
Port Number MDIX Mode
------------- ------------------
ge.1.27 MDIX
ge.1.28 MDIX
set port mdix
Use this command to configure cable connection type configuration mode for one or more ports.
Syntax
set port mdix {auto|forced-auto|mdi|mdix} [port-string]
Parameters
all Display information about all ports.
auto Display information about the ports configured to automatically
determine the required MDI/MDIX mode.
forced-auto Display information about the ports forced automatically to determine
the required MDI/MDIX mode.
mdi Display information about the ports configured with MDI only mode.
mdix Display information about the ports configured with MDIX only mode.
port-string (Optional) Display the selected MDI/MDIX mode only for the port or
ports specified.
auto Configure ports to automatically determine the required MDI/MDIX
mode. This is the default condition.
forced-auto Force ports to automatically determine the required MDI/MDIX mode.
To Next Page
Loading...
Need help?
General