Enterasys C3G124-24 - Clear Linkflap Action

clear linkflap action
Enterasys C3 Configuration Guide 11-29
Parameters
Defaults
None.
Mode
Switch mode, read-write.
Example
This example shows how to set the link flap violation action on port ge.1.4 to generating a Syslog
entry.
C3(rw)->set linkflap action ge.1.4 gensyslogentry
clear linkflap action
Use this command to clear reactions to a link flap violation.
Syntax
clear linkflap action port-string {disableInterface | gensyslogentry | gentrap |
all}
Parameters
Defaults
If port-string is not specified, actions will be cleared on all ports.
Mode
Switch mode, read-write.
Example
This example shows how to clear the link flap violation action on port ge.1.4 to generating a
Syslog entry.
C3(rw)->clear linkflap action ge.1.4 gensyslogentry
port-string Specifies the port(s) on which to set the link flap action.
disableInterface Sets the reaction as disabling the interface.
gensyslogentry Sets the reaction as generating a syslog entry.
gentrap Sets the reaction as generating an SNMP trap.
all Sets the reaction as all of the above.
port-string Specifies the port(s) on which to clear the link flap action.
disableInterface Clears the reaction as disabling the interface.
gensyslogentry Clears the reaction as generating a syslog entry.
gentrap Clears the reaction as generating an SNMP trap.
all Clears the reaction as all of the above.