Enterasys C3G124-24 - Clear Dhcp Pool Domain-Name; Set Dhcp Pool Domain-Name

set dhcp pool domain-name
Enterasys C3 Configuration Guide 22-25
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example removes the DNS server list from the address pool “auto1.”
C3(rw)->clear dhcp pool auto1 dns-server
set dhcp pool domain-name
Use this command to specify a domain name to be assigned to DHCP clients served by the address
pool being configured.
Syntax
set dhcp pool poolname domain-name domain
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example assigns the “mycompany.com” domain name to the address pool “auto1.”
C3(rw)->set dhcp pool auto1 domain-name mycompany.com
clear dhcp pool domain-name
Use this command to remove the domain name from the address pool being configured.
Syntax
clear dhcp pool poolname domain-name
poolname Specifies the name of the address pool. Pool names may be up to 31
characters in length.
poolname Specifies the name of the address pool. Pool names may be up to 31
characters in length.
domain Specifies the domain name string. The domain name can be up to 255
characters in length.