Enterasys C3G124-24 - Commands; Set Cos State

set cos state
Enterasys C3 Configuration Guide 15-21
Commands
set cos state
Use this command to enable or disable Class of Service.
Syntax
set cos state {enable | disable}
Parameters
Defaults
None.
Mode
Switch command, read-write.
For information about... Refer to page...
set cos state 15-21
show cos state 15-22
clear cos state 15-22
set cos settings 15-23
clear cos settings 15-24
show cos settings 15-24
set cos port-config 15-25
show cos port-config 15-26
clear cos port-config 15-27
set cos port-resource irl 15-28
set cos port-resource flood-ctrl 15-29
show cos port-resource 15-30
clear cos port-resource irl 15-31
clear cos port-resource flood-ctrl 15-32
set cos reference 15-32
show cos reference 15-33
clear cos reference 15-34
show cos unit 15-35
clear cos all-entries 15-36
show cos port-type 15-36
enable | disable Enables or disables Class of Service on the switch. Default state is
disabled.