Enterasys C3G124-24 - Clear Cos Port-Resource Flood-Ctrl; Set Cos Reference

clear cos port-resource flood-ctrl
15-32 Policy Classification Configuration
clear cos port-resource flood-ctrl
Use this command to clear flood control port resources to default values.
Syntax
clear cos port-resource flood-ctrl {all | group-type-index {unicast | multicast |
broadcast | all [rate]}}
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example clears the unicast port resource for port group 1.0 to default values.
C3(su)->clear cos port-resource flood-ctrl 1.0 unicast
set cos reference
Use this command to set the Class of Service inbound rate limiting reference configuration.
Syntax
set cos reference irl group-type-index reference rate-limit irl-index
all Clear all flood control resources for all port groups.
group-type-index Specifies a port group/type index. Valid entries are in the form of
group#.port-type.
Valid values for group# can range from 0 to 7. Valid values for port-type
can range from 0 to 1, although only port type 0 is currently supported.
For example, port group 3 would be specified as 3.0.
unicast Clear unicast port resources for the specified port group.
multicast Clear multicast port resources for the specified port group.
broadcast Clear broadcast port resources for the specified port group.
all Clear all flood control port resources for the specified port group.
rate (Optional) Clear the data rate limiter of the specified type of port
resource to the default (none or disabled).