Enterasys C3G124-24 - Show Pwa Session

show pwa session
Enterasys C3 Configuration Guide 32-87
Parameters
Defaults
If port-string is not specified, PWA will enabled on all ports.
Mode
Switch command, read-write.
Example
This example shows how to enable PWA on ports 1-22:
C3(su)->set pwa portcontrol enable ge.1.1-22
show pwa session
Use this command to display information about current PWA sessions.
Syntax
show pwa session [port-string]
Parameters
Defaults
If port-string is not specified, session information for all ports will be displayed.
Mode
Switch command, read-only.
Example
This example shows how to display PWA session information:
C3(su)->show pwa session
Port MAC IP User Duration Status
-------- ----------------- --------------- ------------- ------------ ---------
ge.2.19 00-c0-4f-20-05-4b 172.50.15.121 pwachap10 0,14:46:55 active
ge.2.19 00-c0-4f-24-51-70 172.50.15.120 pwachap1 0,15:43:30 active
ge.2.19 00-00-f8-78-9c-a7 172.50.15.61 pwachap11 0,14:47:58 active
enable | disable Enables or disables PWA on specified ports.
port-string (Optional) Sets the control mode on specific port(s). For a detailed
description of possible port-string values, refer to “Port String Syntax Used
in the CLI” on page 11-1.
port-string (Optional) Displays PWA session information for specific port(s). For a
detailed description of possible port-string values, refer to “Port String
Syntax Used in the CLI” on page 11-1.