set summertime
3-16 Basic Configuration
set summertime
Use this command to enable or disable the daylight savings time function.
Syntax
set summertime {enable | disable} [zone]
Parameters
Defaults
If a zone name is not specified, none will be applied.
Mode
Switch command, read-only.
Example
This example shows how to enable daylight savings time function:
C3(su)->set summertime enable
set summertime date
Use this command to configure specific dates to start and stop daylight savings time. These
settings will be non-recurring and will have to be reset annually.
Syntax
set summertime date start_month start_date start_year start_hr_min end_month
end_date end_year end_hr_min [offset_minutes]
Parameters
Defaults
If an offset is not specified, none will be applied.
enable | disable Enables or disables the daylight savings time function.
zone (Optional) Applies a name to the daylight savings time settings.
start_month Specifies the month of the year to start daylight savings time.
start_date Specifies the day of the month to start daylight savings time.
start_year Specifies the year to start daylight savings time.
start_hr_min Specifies the time of day to start daylight savings time. Format is hh:mm.
end_month Specifies the month of the year to end daylight savings time.
end_date Specifies the day of the month to end daylight savings time.
end_year Specifies the year to end daylight savings time.
end_hr_min Specifies the time of day to end daylight savings time. Format is hh:mm.
offset_minutes (Optional) Specifies the amount of time in minutes to offset daylight
savings time from the non-daylight savings time system setting. Valid
values are 1 - 1440.
To Next Page
Loading...
